It is quite evident these amps are overbuilt and are more than capable of handling the additional load without breaking a sweat! If you read the original Linear Power manual, they caution against running the amp in 8 ohm mode powering 4 ohm speakers. After a call with Linear Power, it was suggested I set the amp to the 8 ohm taps to run the 8 and 4 ohm Dyno tests. ![]() ![]() Amp is less efficient in this mode and also produced less power. ![]() We initially ran all of the tests using the 4 ohm power supply taps, which lowered rail voltage and increased current. Unlike most of the mono amplifiers of today, this 8002 is capable of reproducing the entire 20Hz - 20kHz frequency range. It was available from 1991-1997 and sold at a MSRP of $1599. The Linear Power 8002 was an 800 Watt single channel amplifier optimized for 8 and 4 ohm loads. ![]() Early 90's Linear Power 8002SW 800W Mono Amplifier
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |